Enviro-Lift
Paint & Coating Stripper
Product Description
Enviro-Lift Paint & Coating Stripper effectively lifts urethanes, alkyds and interior architectural coatings from nearly all substrates including steel, aluminum, concrete, masonry and wood.
Safely use Enviro-Lift in any area where worker safety, damage to delicate equipment or environmental factors may be a concern.
- Low VOC / Low Odor
- Water Based and Biodegradable
- Non-Flammable
- Contains No T AP’s or HAP’s
(Toxic/Hazardous Air Pollutants)
- Easy clean up with soap and water or denatured alcohol
- Non-ozone depleting
- Sprayed with standard equipment
- Does not affect glass
Intended Uses:
- Safe to use in occupied or low ventilation areas.
- Safely and effectively removes architectural coatings from walls and ceilings of building interiors.
- Use to remove uncured floor coatings and floor application mishaps.
Product Characteristics
Viscosity: 6000-15000 cPs
Appearance: Off White Emulsion
Specific Gravity: 1.01
Boil/Freeze Point: >100°C / 0°C
pH: 9-11
Flash Point: > than 100°C
VOC: 440 g/L or 67 g/L (alternate method)
Shelf Life: 24 months, unopened @ 45°F to 75°F
Storage: 45°F-90°F: Keep from freezing or prolonged exposure to sunlight and heat. Keep closed during storage.
Theoretical Coverage Rates: 25-90 sq.ft./gallon
Packaging Information
Packaging:
1 gallon plastic jug (4 per case)
5 gallon pail (individual pails)
Weight:
1 gallon = 10 lbs
5 gallon = 46 lbs
Class 55
Other Considerations
Surface temperatures should be at 50°F to 95°F.
Enviro-Lift performs effectively at lower temperatures, however the dwell time must be increased. Above 85°F (30°C), product may need to be over applied, re-applied or covered with plastic to prevent drying during dwell time.
Enviro-Lift will not strip novalac epoxies. This product is not approved for aviation use.
Safety Requirements
Proper safety procedures should be followed at all times while handling this product. Refer to the Material Safety Data Sheet for important health/safety information before use.
Do not collect and/or store removed paint and stripper waste residue in metal containers. Only use plastic containers.
WARNING! If you scrape, sand, or remove old paint, you may release lead dust or fumes. LEAD IS TOXIC. EXPOSURE TO LEAD DUST OR FUMES CAN CAUSE SERIOUS ILLNESS, SUCH AS BRAIN DAMAGE, ESPECIALLY IN CHILDREN. PREGNANT WOMEN SHOULD ALSO AVOID EXPOSURE. Wear a properly fitted NIOSH-approved respirator and prevent skin contact to control lead exposure. Clean up carefully with a HEPA vacuum and a wet mop. Before you start, find out how to protect yourself and your family by contacting the USEPA National Lead Information Hotline at 1-800-424- LEAD or log on to www.epa.gov/lead. In Canada contact a regional Health Canada office. Follow these instructions to control exposure to other hazardous substances that may be released during surface preparation.
Contact Information
For further technical questions or warranty issues, please call the Manufacturer at:
GENESIS COATINGS, INC. (800) 533-4273